View source for Sept 2009 Field Trip

This is a to do list  detailing work to be done on the Sept 2-13 field trip. 
Stream Team (Ken, Emily, Horacio/Bill, Rob) Sept 2-9 or so working out of Prudhoe first, then moving to Toolik.
Met Team (Mike L., Jeff D., 3rd person) Sept 9-13 or so working out of Toolik.

Remember to make reservations at Toolik (& bring your own sleeping bag/sheets/blankets/pillow)
Remember to get rooms in Deadhorse
Bill or Horacio arrive Sept 3?

== Day 0, Drive to Deadhorse (Sept 1/2) ==


== Day 1, 2, 3 Shaviovik, U1, Kadleroshilik River, Bullen DBM8, Lower Kad DBM7 helicopter sites (begin flying evening of Sept 2 or morning of Sept 3==
1.  [[Shaviovik River | Shaviovik R]]:  
* Water Level Survey
* Move/secure PTs
* Install 6' rebar for new and better TBM (install to 5' deep?)
* Discharge Measurement

2. [[No Name River U1| U1 Cr]:  
* Water Level Survey
* Move/secure PTs
* Install 6' rebar for new and better TBM (install to 5' deep?)
* Discharge Measurement

3. [[Kadleroshilik River| Kadleroshilik R]]:  
* Water Level Survey
* Move/secure PTs
* Install 6' rebar for new and better TBM (install to 5' deep?)
* Discharge Measurement

4. [[dbm7| DBM7 Kadleroshilik Met]]
*  Possibly move portion of station due to cut bank erosion.
* '''Replace SR50.'''  Measure old distance to ground and then measure new dist. after installation.
* GWS YSI Air T Thermistor #1 is bad 

5. [[dbm8| DBM8 Bullen Met]] 
* '''Replace SR50.'''  Measure old distance to ground and then measure new dist. after installation.

6. [[dbm3| DBM3 Juniper Met]]  
*Replace rain gage mesh 

== Day 4 (Anaktuvuk River, Itkillik River, Chandler River) helicopter sites ==




8. [[dbm4| DBM4 Sag-Ivi Met]] DBM4:  
* '''Check E-Fence'''


9. [[dbm5| DBM5 Upper Kad Met]] DBM5:  
* Add bark chips, trim vegetation 
* Measure distance from ground to snow sensor
* Take photos of site and snow sensor area
* '''Add E-Fence???'''

10. [[dbm6| DBM6 Kavik Met]]:  
* Add bark chips, trim vegetation 
* Measure distance from ground to snow sensor
* Take photos of site and snow sensor area

== Day 4 & 5 (Mountain Sites) helicopter sites ==

11. [[dbr2| DBR2 Ribdon Repeater]] DBR2 Troubleshooting
* Needs HMP45C
* Needs YSIx3
* Add conduit

12. [[dbm3| DBM3 Juniper Met]] DBM3  
* North fence needs another post, 
* solar panel wires are exposed, needs "plates" or other protection
* install conduit
* Swap HMP45C 
* Add bark chips, trim vegetation  (if needed)
* Measure distance from ground to snow sensor
* Take photos of site and snow sensor area

13. [[dbm1| DBM1 Accomplishment Cr Met]] 
* Swap HMP45C 
* install conduit if time permits
* install solar panel plate (larger size)
* Add bark chips, trim vegetation (if needed)
* Measure distance from ground to snow sensor
* Take photos of site and snow sensor area

14. [[dbm2| DBM2 Ribdon Cr Met]] DBM2
* Swap HMP45C
* install conduit
* Add bark chips, trim vegetation (if needed)
* Measure distance from ground to snow sensor
* Take photos of site and snow sensor area

== ''Other TO DO things not helicopter related'' ==

== Emily and Rob head up to Deadhorse and gage the Put River Sept 6-7 ==
*Remember to check [[NSF Sites Notes from Bob]]

== Imnaviat Flume ==
*Install a new larger solar panel and battery
*Gage the site
*repairs to wingwalls as needed
*See [[NSF Sites Notes from Bob]]

== Upper Kuparuk ==
*Gage the site
*See [[NSF Sites Notes from Bob]]

== Toolik snow sensor test site ==

*Toolik Geonor T200B precip gauge site prep

** select site location
*** need 120VAC power
** install concrete base block
*** dig hole for about 6CF concrete
*** prepare template for 4 bolts, 225cm apart
*** mix and place concrete
*** set bolts in place; orient N-S and E-W, leave 6" above surface
*** protect from elements etc. until set
** sensor to be installed later...

*Install SR50 snow sensor
**SR50's, wood chips, etc.
**Mounting equipment
**datalogger
**hmp45c/anememometer?
**wood chips
**Battery, solar panel, charge controller ?
**radio/antennae?