137.229.92.213: Created page with "To Do: * Replace all SR50A snow transducers 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D tools required: * phillips screw driver * 1/4" nutdriver if you remove the senso..."

2016-07-22T22:14:05Z

Created page with "To Do: * Replace all SR50A snow transducers ** 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D ** tools required: *** phillips screw driver *** 1/4" nutdriver if you remove the senso..."

New page

To Do:
* Replace all SR50A snow transducers
** 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D
** tools required:
*** phillips screw driver
*** 1/4" nutdriver if you remove the sensor from the stand to swap out.
*** 1/2" wrench/nut driver if you remove the sensor.
** Also, check
* Swap out all Wind Speed Sensors
** 3m @ A, B, C will require a ladder
** 1.2m @ A,B, C, D
** These are Met One 014A sensors so the tricky part I think will be the corrosion. The sensor cable screws on the base which I think won't be too bad but might require a channel lock.
** The cups though will require an allen wrench, small, and the corrosion may make removing them all but impossible. I'm not sure.
** we'll need to add anti corrosion goo to the fittings on replacement, too.
* check level on radiometers

To Bring:
* 014A replacements
* couple small tools
** 1/2" wrench/nut driver
** 1/4" wrench/nutdriver
** metric allen wrenches
**
* ladder
* SR50A transducers
*

NGEE Barrow September 2016 - Revision history

137.229.92.213: Created page with "To Do: * Replace all SR50A snow transducers ** 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D ** tools required: *** phillips screw driver *** 1/4" nutdriver if you remove the senso..."

137.229.92.213: Created page with "To Do: * Replace all SR50A snow transducers 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D tools required: * phillips screw driver * 1/4" nutdriver if you remove the senso..."