Kougraok M64

Tape Color is Green

In NGEE Container:

• Tripod base with green tape. This is in NGEE Container
  • Requires 1.25" schedule 40 pipe mast

In UAF Storage

• 1" x 3' aluminum pipe, three pieces
• 2 pipe wrenches
• large cable ties
• small cable ties
• fish tape
• 4 dog anchors
• saw
• grease
• anti oxidizing grease for electrical connections
• a bunch of hose clamps (including for precip bucket
• Bosch drill
• GIPL drill bit

Sensors in UAF storage

• Tipping bucket
• GIPL VATP

To Buy in Nome

• At Grizzly Hardware pick up a 1.25" schedule 40 pipe threaded on one side

To buy in Fairbanks

• 1" topper for tripod past -Lily asks what is this? (These two items connect RM Young anemometer to the top of the tower)
• 1" to 1.25" coupler to replace one used at teller top site -Lily asks if we still need this?

Cross arm situation

• Use short 1" Aluminum pipe for precip stand at site. Have three of these in the UAF Nome storage as well as the brackets required.
• the hose clamps for the site are in Nome along with some other items.

To ship from Fairbanks

• 2 pcs 12V batteries

Sensors

Sensors

instrument	SN	where?	height	cable	mount	crossarm	crossarm mount
HMP155A		7pcs in UAF Storage	1.5meters	?	yes and shield	na	na
RMyoung		?	3meters	?	in box	in box	Frontier supply stocks them
Barometric pressure		?	na	?	na	na	na
CNR4		in box		in box	in box
3 NDVI sensors		in box	color coded, see SRS notes	attached	in box
3 PRI sensors		in box	color coded, see SRS notes	attached	in box
Skin Temp		in box		attached	in box
5 soil moisture		in box	color coded, see hydraprobe notes	attached	na	na	na
4 thermal conductivity		only one in box
VAPT		UAF Storage
SR50a?		UAF Storage... I may have stolen the transducer though...		need longer cable for far one
tipping bucket		In Nome Storage			?

Hydra Probe notes

• ID 0 = 5cm = red
• ID 1 = 10cm = orange
• ID 2 = 20cm = purple
• ID 3 = 30cm = brown
• ID 4 = 40cm = black

SRS notes

• PRI up = red tape = 7 SDI address
• PRI #1 = orange = 8 SDI address
• PRI #2 = purple = 9 SDI address
• NDVI up = red tape = A SDI address
• NDVI #1 = orange = B SDI address
• NDVI #2 = purple = C SDI address

Measure resistor value and SN beforehand?

infrastructure

• tower
  • tripod - in storage
  • mast- called Grizzly 907 443 2108 to see if we can reserve one
  • alter shield for tipping bucket?
• power
  • solar panel
  • wires for panel
  • charge controller
  • crips/connectors for charge controller wires
  • 2 big batteries
  • connector wires for batteries
  • wire to logger
  • fuse
• Enclosure
  • mount for enclosure
  • logger
  • mux
  • wires between mux and logger
  • cable
  • printed program
  • screw driver
  • CFM100+card

Actionpacker in uaf storage

• Cable Ties
• 2 pipe wrenches
• hose clmaps
• three camping dinners (seafood deals)
• a bit more snacks
• fish tape
• soil samplers for teller bottom
• duct seal
• grease & anticorrosion goo
• (2) switched 12 volt control
• saw for dirt
• dog anchor
• box screw driver & serial cable (2)
• drill charger
• test radio for kougarok conenctions
  • need a cigarette adapter
• hobo kit
• SR50A for K2 & K3
• 1" x 1" ubolt cross arm bracket
• 1" x 1.5" ubolt cross arm bracket
• 1" x 1" nurail cross
• 1" x 3/4" nurail cross
• LANL cameras
• bubble wrap

General actionpacker placed into storage but may be useful for K64

• Misc ubolts
• misc unistrut clamps (mostly wrong sizes I suspect)
• four pieces of unistrut 12-18 inches. two half size two full size
• three things of electrical tape, duct tape, rubber splicing tape
• couple NRS straps 9 & 12 feet
• 1 8GB CF card
• misc wire
• misc other
• baking soda

Checklist for bob to find in Nome

• Tripod kit -- Tripod is in NGEE conex
• trail mat for underneath tripod -- I'm not sure if we have any left
• Batteries for new K64 met tower -- The batteries are in room 112 in basement, or at least one, there are a couple others out there.
• tipping bucket
  • hose clamps for mounting it
  • cable (how long is it?)
• wind sensor
  • cable
• 1 SR50a sensor
  • cable (how long is it?)
  • mounting kit?
• Barometer
  • cable
  • what kind of screws do I need to mount it in the enclosure?
• VATP -- it is in Nome
  • is there a resistor taped to it?
• HMP155
  • cable
• sledge hammer
• shovel
• Drill for VATP
• Is Bob Bolton's sleeping bag there?
• if time: buy mast at Grizzly