Difference between revisions of "Oliktok summer 2017 trip"
Jump to navigation
Jump to search
Line 21: | Line 21: | ||
**white -- AG | **white -- AG | ||
− | |||
− | |||
*CFM100 | *CFM100 | ||
Line 29: | Line 27: | ||
**3)re-plug power to the logger | **3)re-plug power to the logger | ||
**4) | **4) | ||
+ | |||
*level geonor | *level geonor | ||
+ | **there are screws at the base | ||
+ | **don't do this if it doesn't seem obvious | ||
*tools i'm sending you with | *tools i'm sending you with | ||
Line 35: | Line 36: | ||
**small flathead screw driver | **small flathead screw driver | ||
**small Philips screw driver | **small Philips screw driver | ||
+ | **level | ||
+ | |||
====other=== | ====other=== | ||
*antifreeze | *antifreeze | ||
*snip vegetation underneath | *snip vegetation underneath | ||
+ | **cable housing | ||
+ | *plastic cable covers for all cables entering into the logger? |
Revision as of 12:48, 7 September 2017
for telayna
- replace sr50a transducers
- 1)unscrew sensor from mount
- 2)unscrew cable from sensor
- 3)unscrew all little screws holding the transducer to the sensor body (use the frisbee to work so you don't lose the little screws)
- 4)unclip the wires of the old transducer, remove the O ring
- 5)place desiccant in the new transducer
- 5)place the new O ring on the sensor body and clip the new transducer wire
- 6)line up the notch of the new transducer on the sensor body
- 7)screw in all the little screws
- 8)replace the sensor on the mount and screw in the cable (which is notched)
- put up temperature sensor
- mount it as close to SR50a quadpod as possible
- wiring to CR1000 logger
- Red -- SW-12
- yellow -- SE11
- blue -- SE12
- clear -- AG
- black -- AG
- white -- AG
- CFM100
- 1)unplug power from logger
- 2)plug and screw in the CFM100
- 3)re-plug power to the logger
- 4)
- level geonor
- there are screws at the base
- don't do this if it doesn't seem obvious
- tools i'm sending you with
- 7/16 nut driver
- small flathead screw driver
- small Philips screw driver
- level
=other
- antifreeze
- snip vegetation underneath
- cable housing
- plastic cable covers for all cables entering into the logger?