Difference between revisions of "SS Naoki Site visit 2023-05-03"
Jump to navigation
Jump to search
(Created page with "Installation of SmatFlux 2 (SM2) -----Site Overview----- Rapid snow melt in progress. Snow has become very slushy with standing water in some areas. ------Work Memo------...") |
(No difference)
|
Revision as of 03:15, 5 May 2023
Installation of SmatFlux 2 (SM2)
Site Overview-----
Rapid snow melt in progress. Snow has become very slushy with standing water in some areas.
Work Memo------
Installation process itself went smoothly with no surprise. However, the software does not show the newly installed SM2 in the "choose a smartflux" window. (Prior to the installation, a device was shown in the this window but it had disapered)
Troubleshooting was not successful I tried following
- followed the network trouble shooting guide in the SM2 manual (pressing the reset button on SM2 and LI7550)
- double checked all the connections/wiring
- LED indicators on SM2 and LI7550 seemed normal
- flow module is on and set at 15.0
I did NOT re-start the PC or the software in fear of causing disruption in data collection process.
I wonder if this had been caused by turning the LI7550 off as part of the installation procedure.
Further troubleshooting is needed.
