Difference between revisions of "NGEE Barrow 2013 Site Install Trip"
Jump to navigation
Jump to search
| Line 53: | Line 53: | ||
| − | + | ===Rough on-site todo=== | |
# Copy wiring of Grid Site | # Copy wiring of Grid Site | ||
# Transfer wires to new multiplexer & Logger | # Transfer wires to new multiplexer & Logger | ||
| Line 59: | Line 59: | ||
# Measure Heater Resistances for all thermal conductivity probes | # Measure Heater Resistances for all thermal conductivity probes | ||
# Look to see if the C site pit 2 thermal conductivity sensors could be connected to a lower instrument enclosure. | # Look to see if the C site pit 2 thermal conductivity sensors could be connected to a lower instrument enclosure. | ||
| + | # configure C as pakbus router for grid | ||
| + | ## http://www.campbellsci.com/forum/messages.cfm?threadid=6E4ABAA0-81A1-4158-B850230D8A56A2EF | ||
| + | # armor and run rs485 line between C and grid | ||
Revision as of 21:52, 4 May 2013
Contents
May 2013 Trip
Purpose:
- Rewire Grid Site station with CR1000 & new multiplexers
- Setup MD485s to get Grid online
- reconfigure Site C CR1000 for act as a pakbus router
- Snow Surveys
- Any other prep that's possible for the June trip
- Bring back shotgun
- slather anticorrosion goo on all 12V/G points?
- Record Thermal Conductivity Heater Resistance using a high-accuracy ohmmeter
- Swap out SR50A
Shipping
- None
To Purchase
- Anti-Corrosion Goo
- Ziplocs
- In Barrow:
- Butane
- Food?
Pre-trip to do
- Read up on CR1000 Pakbus Routing
- Pack
Stuff to bring
- Adirondack Tube
- Scale
- Thaw Probe
- Ziplocs
- GPS
- 4 Precision Resistors for new logger
- High Precision Voltmeter
Technical Gear
- Shotgun -- in Barrow already
- Keypads
- fish tape
- Tool Bags
- Computer & (packed) SC32B
- Climbing harness
- Serial Cables & spares
- Sawzall
- drill
Food to bring out
- Optional
Probable Luggage
- Bob Personal Actionpacker [Bob #1]
- Work Actionpacker #1 [Bob #2]
Rough on-site todo
- Copy wiring of Grid Site
- Transfer wires to new multiplexer & Logger
- Snowsurveys
- Measure Heater Resistances for all thermal conductivity probes
- Look to see if the C site pit 2 thermal conductivity sensors could be connected to a lower instrument enclosure.
- configure C as pakbus router for grid
- armor and run rs485 line between C and grid
