Dfm2

site TODO list

• record as-built wiring of soil sensors
• Flex conduit as needed

• Site had bear damage need to
  • replace anemometer cable
  • replace solar panel
  • repair electric fence
  • install flex conduit
  • Check electric fence

site logs

• bring 2 posts, post driver, wire insulators; install posts midway in long runs
• secure rain gauge funnel
• flex conduit for antenna, other cables
• bring turnbuckle for N guy

28 August 2007 11:30a, Rob Gieck.

(entered by E. Youcha from Rob's field book)

• looks like they took off the SR50 with SN C4801 and put on SR50 with SN 4802
• took distance measurements with circle (cone) method, 2 ft out from sensor: N=117.7 cm, E=119, W=115, S=119.4
• I think the HMP45C was replaced (old SN B0110036 - new SN C11430045)
• fence looked in place

13 July 2007, Ken I.

• electric fence working; taped yellow tags near posts
• fence could use two more posts in middle of long runs
• tightened both wires on NE fence run
• rain gauge funnel not secured
• tripod looks good; guys are a little slack
• site could use flex conduit on tripod wires
• radiation pole is plumb; cables a bit slack
• need turnbuckle on N guy (now secured with nylon cord)
• snow depth sensor off plumb; fitting looks bent; straightened/bent it back, but not quite vertical

9 June 2007, Ken I., Dan R.

• old site dismantled for later removal:
  • battery box: about 220 pounds, including 3 batteries
  • tower/stand: about 100 pounds
  • solar panel REMOVED

• electric fence put up using 4 posts