Difference between revisions of "Spring 2017 visit"

Revision as of 15:23, 1 June 2017

Check out the status of the heater wiring for CNR4
- is it even wired? to which ports?
- change the program notes if wired
- change program controls for heater
- bring up couple SW12V
change desiccant in CNR4

stabilize underwater par sensor with second string for cleaning
add terrestrial quantum to sensor wiring notes at top of program
check what the calconnector looks like for lake PAR.
- maybe need to buy a second one so can coordinate with calibration swaps
- its reading negative because the sensor head was swapped wrong, but this isn't an issue.
change notes in program where measure pressure to change CS100 to CS106
- remove sea level offset
get serial number for radios
get height of terrestrial PAR
check if pluvio is pointing north
think about soil temps- at least find them
install BF5 sensor
- tripod is 9ft7in from tower. cable is 5m. so this should work out
- bring some spare AC power line, inverters and plugs to set up power for heater.
set up evap pan
organize the enclosure
- zip ties of many colors and sizes
- wires of many colors (mostly red and black)
- white wire connector things

Clothes

Other Gear

@@ Line 1: / Line 1: @@
+===CNR4===
 * Check out the status of the heater wiring for CNR4
 ** is it even wired? to which ports?
@@ Line 5: / Line 6: @@
 ** bring up couple SW12V
 *change desiccant in CNR4
 *stabilize underwater par sensor with second string for cleaning
 *add terrestrial quantum to sensor wiring notes at top of program
@@ Line 25: / Line 28: @@
 **white wire connector things
-at toolik:
+===at toolik===
 *go through all metadata - remember the comments column
 *think about PAR sensors