Difference between revisions of "2016 Summer Nome Trip"
Jump to navigation
Jump to search
Line 102: | Line 102: | ||
** Try looking for this early in the trip... if you don't find it I have an alternate plan involving the bridge at the Teller site. Also includes one medium size crescent wrench. | ** Try looking for this early in the trip... if you don't find it I have an alternate plan involving the bridge at the Teller site. Also includes one medium size crescent wrench. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
Line 123: | Line 114: | ||
* touch base with Mike Murphy | * touch base with Mike Murphy | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
Revision as of 09:16, 12 July 2016
First Trip To Do:
- in Town
- buy
- spray foam (builders industrial supply
- bear spray (sporting goods store by milanos pizza)
- UAF storage
- get a weight at the UAF nome storage for teller water probe
- bear spray
- shovel
- buy
- @ Teller
- Lily / Bill -- initialize & install surface water probes (Hobo)
- Mark each with colored tape
- set measurement interval to once per 15 minutes
- will be co-located with LANL Isco Samplers (requiring coordination with Brent / Cathy )
- Located at Point TL_ISCO_2
- Located at Point TL_ISCO_3
- See Teller_SamplePlan_GeoPDF_20160707.pdf
- If you are accessing Maps from Bob Busey's dropbox share, these are here: ~/Dropbox/GeoPDFs/2016_summer/
- Bob Bolton -- measure discharge @ bridge
- I was measuring on the upstream side of the bridge with the measuring tape strung from one side to the other.
- note water level above screed stakes in channel:
- furthest into the channel on the right bank side, upstream 1-1.5m is #1
- If they are exposed (likely) then measure stage above PT as well as stage immediately up stream of the screed stake.
- Lily / Bill -- download data from:
- take pictures at all sites!
- Radiation site at top of drainage
- snow temperature site at basin surface water gaging site (& you can turn off the system / disconnect the battery)
- surface water station
- Lily / Bill -- initialize & install surface water probes (Hobo)
- @ Kougarok
- if time allows, download data over radio network from Quartz Creek Air field
- Flag 1 leave radios on full time
- K1, K2, K3 to retrieve from.
- if time allows, download data over radio network from Quartz Creek Air field
@ Council
- if time allows download blueberry over radio network.
- ATD8785624
- if time allows download blueberry over radio network.
Contents
Onset Surface Water Hobo Details
- Positioned alongside ISCO samplers. ISCO Point 1 is the 4/2016 installed surface water station.
- Place one at Point TL_ISCO_2, -165.94618 64.72903
- Place second at Point TL_ISCO_3, -165.94692 64.72634
- Set Measurement interval to once per fifteen minutes.
- Please record water level over sensor and the time (note timezone) at deployment.
- Pictures of the install location are excellent, too
LoggerNet Details
Teller Sites
- change file names in the setup window
- Surface Water Station
- Location: Near Map Point TL_SG_36 / TL_DS_1
- -165.95584 64.73377
- LN Name: snowmelt_blue
- PakbusID: 314
- Data File Naming Format: snowmelt_blue_MicroMet.dat, snowmelt_blue_waterlevel-yyyy_mm_dd.dat
- Location: Near Map Point TL_SG_36 / TL_DS_1
- Snow Temperature Site (the one Cathy & Lily built but sitting on ground without tripod)
- Location: Near Map Point TL_SG_36 / TL_DS_1
- -165.95584 64.73377
- LN Name: snowmelt_yellow
- PakbusID: 313
- Data File Naming Format: Snowmelt_Yellow_Snowmelt-yyyy_mm_dd.dat
- (Please unplug battery after downloading data)
- Location: Near Map Point TL_SG_36 / TL_DS_1
- Snowmelt Top of Drainage
- Location: At Map Point TL_MJ_2: -165.96979 64.74555
- LN Name: snowmelt_top (has red tripod)
- PakbusID: 25
- Data File Naming Format: snowmelt_top_Snowmelt-yyyy_mm_dd.dat
- General note, the surface water site is set to upload to my dropbox account. If you allow it to go online and sync then I can process the data from Fairbanks to make sure things are good out there.
Older Sites
- Kougarok Burn site
- LN Name: K1-Burn
- Data File Naming Format: k1_yyyy_mm_dd.dat
- Radio Access: ATD8786907
- Kougarok 10 meter tower
- LN Name: K2-Met
- Data File naming format: k2_yyyy_mm_dd.dat
- Radio Access: ATD8786681
- Try to download this site first and try to download all the data on the storage module
- Kougarok Mauze Gulch Site:
- LN Name: K3-Mauze
- Data File Naming Format: k3_yyyy_mm_dd.dat
- Radio Access: ATD8737574
- Kigluaiks
- LN Name: Kigluaiks
- Data File Naming Format: Kigluaiks_yyyy_mm_dd.dat
- Radio Access: ATD8786669
- C1 Grid
- LN Name: C1Grid
- Data File Naming Format: c1_grid_yyy_mm_dd.dat
- C2 Blueberry 10 meter tower
- LN Name: C2Blueberry
- Data File Naming Format: c2_blueberry_yyyy_mm_dd.dat
- Radio Access: ATD8786524
To bring back (trip 1):
- All the old precip buckets up high in the uaf storage
- A lot of photos if possible of the storages in Nome & Kougarok for a photo inventory. I took a bunch in May but most were too blurry to be useful.
- bring back scaffold clamp from UAF storage
- Try looking for this early in the trip... if you don't find it I have an alternate plan involving the bridge at the Teller site. Also includes one medium size crescent wrench.
PRs:
- batteries for small sites
- solar panels for small sites
- freight to Nome
TA:
- car
- touch base with Mike Murphy
Inventory:
Met
- snow sensors
- 4 Judd voltage out
- 6 SR50A
- 9 HMP155 shields
- 1 RM Young WS/WD
- 8pcs 014A WS (for Barrow)
- 1 pcs 014B WD
- 4-5 WS/WD 05103 Anemometers in need of a bearing replacement
Soil
- 5 heat flux plates
- 15 Hydraprobes
- 8 soil thermal conductivity
- 12 soil heat capacity
Infrastructure
- 5 CSI Boxes
- # assorted brackets
- 4 sunguard 4.5A charge controllers
- 1 sunsaver 6.0A charge controller
- 1 3m Tripod at UPark
- 1 3m tripod kit in IARC106