Difference between revisions of "Oliktok summer 2017 trip"

From IARC 207 Wiki
Jump to navigation Jump to search
Line 21: Line 21:
 
**white  -- AG
 
**white  -- AG
  
**cable housing
 
*plastic cable covers for all cables entering into the logger?
 
  
 
*CFM100
 
*CFM100
Line 29: Line 27:
 
**3)re-plug power to the logger
 
**3)re-plug power to the logger
 
**4)
 
**4)
 +
 
*level geonor
 
*level geonor
 +
**there are screws at the base
 +
**don't do this if it doesn't seem obvious
  
 
*tools i'm sending you with
 
*tools i'm sending you with
Line 35: Line 36:
 
**small flathead screw driver
 
**small flathead screw driver
 
**small Philips screw driver  
 
**small Philips screw driver  
 +
**level
 +
 
====other===
 
====other===
 
*antifreeze
 
*antifreeze
 
*snip vegetation underneath
 
*snip vegetation underneath
 +
**cable housing
 +
*plastic cable covers for all cables entering into the logger?

Revision as of 12:48, 7 September 2017

for telayna

  • replace sr50a transducers
    • 1)unscrew sensor from mount
    • 2)unscrew cable from sensor
    • 3)unscrew all little screws holding the transducer to the sensor body (use the frisbee to work so you don't lose the little screws)
    • 4)unclip the wires of the old transducer, remove the O ring
    • 5)place desiccant in the new transducer
    • 5)place the new O ring on the sensor body and clip the new transducer wire
    • 6)line up the notch of the new transducer on the sensor body
    • 7)screw in all the little screws
    • 8)replace the sensor on the mount and screw in the cable (which is notched)
  • put up temperature sensor
    • mount it as close to SR50a quadpod as possible
    • wiring to CR1000 logger
    • Red -- SW-12
    • yellow -- SE11
    • blue -- SE12
    • clear -- AG
    • black -- AG
    • white -- AG


  • CFM100
    • 1)unplug power from logger
    • 2)plug and screw in the CFM100
    • 3)re-plug power to the logger
    • 4)
  • level geonor
    • there are screws at the base
    • don't do this if it doesn't seem obvious
  • tools i'm sending you with
    • 7/16 nut driver
    • small flathead screw driver
    • small Philips screw driver
    • level

=other

  • antifreeze
  • snip vegetation underneath
    • cable housing
  • plastic cable covers for all cables entering into the logger?