Oliktok summer 2017 trip

for telayna

• replace sr50a transducers
  • 1)unscrew sensor from mount
  • 2)unscrew cable from sensor
  • 3)unscrew all little screws holding the transducer to the sensor body (use the frisbee to work so you don't lose the little screws)
  • 4)unclip the wires of the old transducer, remove the O ring
  • 5)place desiccant in the new transducer
  • 5)place the new O ring on the sensor body and clip the new transducer wire
  • 6)line up the notch of the new transducer on the sensor body
  • 7)screw in all the little screws
  • 8)replace the sensor on the mount and screw in the cable (which is notched)

• put up temperature sensor
  • mount it as close to SR50a quadpod as possible
  • wiring to CR1000 logger
  • Red -- SW-12
  • yellow -- SE11
  • blue -- SE12
  • clear -- AG
  • black -- AG
  • white -- AG

• • cable housing
• plastic cable covers for all cables entering into the logger?

• CFM100
  • 1)unplug power from logger
  • 2)plug and screw in the CFM100
  • 3)re-plug power to the logger
  • 4)
• level geonor

• tools i'm sending you with
  • 7/16 nut driver
  • small flathead screw driver
  • small Philips screw driver

=other

• antifreeze
• snip vegetation underneath