NGEE Barrow Intensive Sites Initial Wiring

General Wiring 2013 (Some minor differences like 3 SR50As at site C)

' SE1  -- CNR4 SW In HI
' SE2  -- CNR4 SW In LO
' SE3  -- CNR4 SW OUT HI
' SE4  -- CNR4 SW OUT LO
' SE5  -- CNR4 LW IN HI
' SE6  -- CNR4 LW IN LO
' SE7  -- CNR4 Dome Temperature Signal
' SE8  -- 107 Probe Signal (Red Wire)
' SE9  -- CNR4 LW OUT HI
' SE10 -- CNR4 LW OUT LO
' SE11 -- AM16/32B #3 COM ODD HI
' SE12 -- AM16/32B #3 COM ODD LO
' SE13 -- AM16/32B #1 COM ODD HI, Precision Resistor to VX2
' SE14 -- AM16/32B #1 COM ODD LO, Precision Resistor to VX2
' SE15 -- AM16/32B #2 COM ODD HI, Precision Resistor to VX3
' SE16 -- AM16/32B #2 COM ODD LO, Precision Resistor to VX3

' VX1 -- 107 Probe Excitation (Black Wire); **CNR4 LW Dome Temperature Excitation**, **RM Young WD Excite**
' VX2 -- Precision resistors to Mux 2 COM ODD HI, SE1, COM ODD LO, SE2
' VX3 -- Precision resistors to Mux 3 COM ODD HI, SE1, COM ODD LO, SE2, 

' P1 -- MetOne 1m WS+
' P2 -- MetOne 3.5m WS+

' C1 -- SDM IO C1
' C2 -- SDM IO C2
' C3 -- SDM IO C3
' C4 -- AM16/32B #1, 2, & 3 -- CLK
' C5 -- SDI 12 Devices Part 1 (6 Vitel Probes ) (Blue Wire)
' C6 -- Vitel Probe CONTROL (Run to SW12V Control for Vitel Probes)
' C7 -- SDI 12 Devices Part 2 (2 SR50A ) (Green Wire)
' C8 -- TE525M Signal
' SW12V -- Radio Power

' Wiring that will need to be moved / extended to the SDM Interface:
' C2 -- AM16/32B #1 -- RES
' C3 -- AM16/32B #2 -- RES
' C8 -- Thermal Conductivity Control

' Signal Ground -- HFP01 Shields (Clear Wire), 107 Probe SG (Purple Wire), SR50A 

' SDM Interface Wiring:
' 1 -- AM16/32B #1 RES
' 2 -- AM16/32B #2 RES
' 3 -- AM16/32B #3 RES
' 4 -- Thermal Conductivity Control
' 5 -- HMP155 Control
' 6 -- CNR4 Heater/Fan Control