Toolik DOT 2011-05-24

From IARC 207 Wiki
Revision as of 20:25, 23 May 2011 by 137.229.91.138 (talk)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

I did it in terminal mode using a themrinal program, hit enter unitl the CR1000> prompt shows, then SDI12 and give hte control port, then you can send sdi12 commands down the line. I tried 0M! and 0D!, but couldn't figure out how to get any data from the sensors, but could tell if a sensor was there. Then 0A4! to change the address, and it was done.