Radio on - off example

This code can be used with CR Basic compatible Campbell Scientific data loggers to power up & down the radio. To leave the radio on, in the Connect view, set the variable (user editable in this case) radioflag to true. When you are ready to leave the radio in the off state (winter for example) set the radioflag to false. Then, to further reduce power consumption you can direct loggernet to turn the radio off after the data retrieval is complete. To do this using the cora command library on linux:

echo "connect localhost; set-variable Radio_Accessible_Site Public commscomplete {} true; quit;" | /opt/CampbellSci/LoggerNet/cora_cmd

Or, from windows, put the following into a DOS batch file:

"c:\Program Files (x86)\Campbellsci\LoggerNet\cora_cmd.exe" < c:\CampbellSci\cora\radio_off.txt

radio_off.txt contains:

connect localhost;
set-variable Radio_Acessible_Site Public commscomplete {} true;
quit;

What follows is the code for the CR Basic Editor. A further modification would be to make the TimeIntoInterval commands use variables for the on & off times.

' Wiring:
' SW12V -- Radio Power

    ''' Diagnostic Variables
    Public batt_volt
    Public Flag(8) As Boolean
    Public radioflag As Boolean  
    Public commscomplete As Boolean

BeginProg

  commscomplete = false
  radioflag=true  
  SW12 (1 )  ' turn on the radio
  Scan(30,Sec, 10, 0)
    '''''''''''''''''''''''''''''''''
    '''''''''''''''''''''''''''''''''
    '' Diagnostic Measurements  '''''
    '''''''''''''''''''''''''''''''''
    '''''''''''''''''''''''''''''''''    
    Battery(batt_volt)
    PanelTemp(Ptemp,_60Hz)
    ''''''''''''''''''''''''''''''''''''''''''''''''''''
    ''''''''''''''''''''''''''''''''''''''''''''''''''''
    '' Radio Control  ''''''''
    ''''''''''''''''''''''''''''''''''''''''''''''''''''
    ''''''''''''''''''''''''''''''''''''''''''''''''''''
    If radioflag=true Then SW12(1)

    ' if the battery voltage is high then turn the radio on hourly 
    If TimeIntoInterval(0,60,min) Then
        If batt_volt >= 12.4 Then 
          SW12(1)
        EndIf
    EndIf
    ' if the battery voltage isn't too low, turn the radio on daily.
    If TimeIntoInterval(720,1440,min) Then
        If batt_volt >= 12.2 Then 
          SW12(1)
        EndIf
    EndIf
    ' if the radioflag hasn't been set manually then turn the radio off 10 minutes into the hour.
    If TimeIntoInterval(10,60,min) OR commscomplete = true Then
        If radioflag = false Then 
          SW12(0)
          commscomplete = false
        EndIf
    EndIf      
    If batt_volt < 12.6 Then radioflag = false