Summer 2016 visit

From IARC 207 Wiki
Revision as of 12:29, 29 August 2016 by 206.174.120.250 (talk)
Jump to navigation Jump to search

Todo list

  • get tower safety trained
  • CANOE out to figure all of underwater sensors out!
    • lake depth, lake par, lake temp
    • measuring tape
    • inspect pressure transducer and change desiccant
    • figure out what is measuring temperature
    • swap underwater quantum
  • replace snow transducer
  • remove old radio antenna
  • bring longer conduit housing for evap pan
  • mesh for pluvio
    • bring wood, nails, hammer
  • guided accuracy test pluvio
  • take down TPS tripod
  • take out base station for old radio? ask jim first- he said ok
  • fix snow depth output/program, right now snow_depth_1 and temp_corr are basically the same and not usefully different
  • BRING PLUVIO USB CABLE
  • ANTIFREEZE for pluvio
  • level radiometers, tipping bucket
  • write plan for cleaning underwater PAR and checking evap pan

accomplished

8/23/16

  • emptied pluvio
  • ran guided accuracy test on Pluvio => now working!
  • lake trip
    • swapped lake par sensor. it is anchored to the bottom 130cm below lake surface that day (attached to the white buoy)
    • pulled up 107 and added it to this anchor
    • pulled up pressure transducer, threw it back out REMEMBER TO ADJUST DATA!!!

8/26/16

  • broke down old TPS tripod (took photos)
  • took out old base station radio, NL100 and kitchen timer
  • added antifreeze mixed with water to the pluvio
  • checked level on tipping bucket- still level
  • leveled total solar radiation
  • leveled UVB + CNR4 (UVA already leveled)
  • replaced snow transducer
  • installed new mesh panel on outer pluvio fence
  • put 107 back on pressure transducer anchor
    • attached orange buoy
    • it was 2m deep on that day, though anchored to bottom