Kougraok M64

From IARC 207 Wiki
Jump to navigation Jump to search

Tape Color is Green

In NGEE Container:

  • Tripod base with green tape. -Lily remembers bob said this was in Nome, is this correct?
    • Requires 1.25" schedule 40 pipe mast

In UAF Storage

  • 1" x 3' aluminum pipe, three pieces
  • 2 pipe wrenches
  • large cable ties
  • small cable ties
  • fish tape
  • 4 dog anchors
  • saw
  • grease
  • anti oxidizing grease for electrical connections
  • a bunch of hose clamps (including for precip bucket
  • Bosch drill
  • GIPL drill bit

Sensors in UAF storage

  • Tipping bucket
  • GIPL VATP

To Buy in Nome

  • At Grizzly Hardware pick up a 1.25" schedule 40 pipe threaded on one side

===To buy in Fairbanks

  • 1" topper for tripod past -Lily asks what is this?
  • 1" to 1.25" coupler to replace one used at teller top site -Lily asks if we still need this?

Cross arm situation

  • Use short 1" Aluminum pipe for precip stand at site. Have three of these in the UAF Nome storage as well as the brackets required.
  • the hose clamps for the site are in Nome along with some other items.


To ship from Fairbanks

  • 2 pcs 12V batteries


Sensors

Sensors
instrument SN where? height cable mount crossarm crossarm mount
HMP155A ? 1.5meters ? yes and shield na na
RMyoung ? 3meters ? in box in box Frontier supply stocks them
Barometric pressure ? na ? na na na
CNR4 in box in box in box
3 NDVI sensors in box color coded, see SRS notes attached in box
3 PRI sensors in box color coded, see SRS notes attached in box
Skin Temp in box attached in box
5 soil moisture in box color coded, see hydraprobe notes attached na na na
4 thermal conductivity only one in box
VAPT hopefully in nome?
SR50a? ?only one in box need longer cable for far one
tipping bucket hopefully in nome? ?


Hydra Probe notes

  • ID 0 = 5cm = red
  • ID 1 = 10cm = orange
  • ID 2 = 20cm = purple
  • ID 3 = 30cm = brown
  • ID 4 = 40cm = black

SRS notes

  • PRI up = red tape = 7 SDI address
  • PRI #1 = orange = 8 SDI address
  • PRI #2 = purple = 9 SDI address
  • NDVI up = red tape = A SDI address
  • NDVI #1 = orange = B SDI address
  • NDVI #2 = purple = C SDI address

Measure resistor value and SN beforehand?

infrastructure

  • tower
    • tripod - in storage
    • mast- called Grizzly 907 443 2108 to see if we can reserve one
    • alter shield for tipping bucket?
  • power
    • solar panel
    • wires for panel
    • charge controller
    • crips/connectors for charge controller wires
    • 2 big batteries
    • connector wires for batteries
    • wire to logger
    • fuse
  • Enclosure
    • mount for enclosure
    • logger
    • mux
    • wires between mux and logger
    • cable
    • printed program
    • screw driver

Actionpacker in uaf storage

  • Cable Ties
  • 2 pipe wrenches
  • hose clmaps
  • three camping dinners (seafood deals)
  • a bit more snacks
  • fish tape
  • soil samplers for teller bottom
  • duct seal
  • grease & anticorrosion goo
  • (2) switched 12 volt control
  • saw for dirt
  • dog anchor
  • box screw driver & serial cable (2)
  • drill charger
  • test radio for kougarok conenctions
    • need a cigarette adapter
  • hobo kit
  • SR50A for K2 & K3
  • 1" x 1" ubolt cross arm bracket
  • 1" x 1.5" ubolt cross arm bracket
  • 1" x 1" nurail cross
  • 1" x 3/4" nurail cross
  • LANL cameras
  • bubble wrap

General actionpacker placed into storage but may be useful for K64

  • Misc ubolts
  • misc unistrut clamps (mostly wrong sizes I suspect)
  • four pieces of unistrut 12-18 inches. two half size two full size
  • three things of electrical tape, duct tape, rubber splicing tape
  • couple NRS straps 9 & 12 feet
  • 1 8GB CF card
  • misc wire
  • misc other
  • baking soda


Checklist for bob to find in Nome

  • Tripod kit
  • trail mat for underneath tripod
  • Batteries for new K64 met tower
  • tipping bucket
    • hose clamps for mounting it
    • cable (how long is it?)
  • wind sensor
    • cable
  • 1 SR50a sensor
    • cable (how long is it?)
    • mounting kit?
  • Barometer
    • cable
    • what kind of screws do I need to mount it in the enclosure?
  • VATP
    • is there a resistor taped to it?
  • if time: buy mast at Grizzly
  • HMP155
    • cable