NGEE Barrow September 2016

To Do:

• Replace all SR50A snow transducers
  • 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D
  • tools required:
    • phillips screw driver
    • 1/4" nutdriver if you remove the sensor from the stand to swap out.
    • 1/2" wrench/nut driver if you remove the sensor.
  • Also, check
• Swap out all Wind Speed Sensors
  • 3m @ A, B, C will require a ladder
  • 1.2m @ A,B, C, D
  • These are Met One 014A sensors so the tricky part I think will be the corrosion. The sensor cable screws on the base which I think won't be too bad but might require a channel lock.
  • The cups though will require an allen wrench, small, and the corrosion may make removing them all but impossible. I'm not sure.
  • we'll need to add anti corrosion goo to the fittings on replacement, too.
• check level on radiometers

To Bring:

• 014A replacements
• couple small tools
  • 1/2" wrench/nut driver
  • 1/4" wrench/nutdriver
  • metric allen wrenches
• ladder
• SR50A transducers