NGEE Barrow September 2016

From IARC 207 Wiki
Jump to navigation Jump to search

To Do:

  • Replace all SR50A snow transducers
    • 2pcs @ A, 2 pcs @ B, 3pcs @ C, 1pcs @ D
    • tools required:
      • phillips screw driver
      • 1/4" nutdriver if you remove the sensor from the stand to swap out.
      • 1/2" wrench/nut driver if you remove the sensor.
    • Also, check
  • Swap out all Wind Speed Sensors
    • 3m @ A, B, C will require a ladder
    • 1.2m @ A,B, C, D
    • These are Met One 014A sensors so the tricky part I think will be the corrosion. The sensor cable screws on the base which I think won't be too bad but might require a channel lock.
    • The cups though will require an allen wrench, small, and the corrosion may make removing them all but impossible. I'm not sure.
    • we'll need to add anti corrosion goo to the fittings on replacement, too.
  • check level on radiometers

To Bring:

  • 014A replacements
  • couple small tools
    • 1/2" wrench/nut driver
    • 1/4" wrench/nutdriver
    • metric allen wrenches
  • ladder
  • SR50A transducers